8401100LD010 Front Grille for JAC N56 — OEM Fit Radiator Grille, Verified Dimensions

8401100LD010 Radiator Grille Assembly for JAC N56 — Direct OEM Replacement, ISO/TS16949 Certified Supply

The Front Grille with OEM number 8401100LD010 is a verified direct-fit replacement for the JAC N56 light truck. This radiator grille is the primary front-end component responsible for directing cooling airflow into the engine compartment while shielding the radiator, engine, and internal components from road debris, insects, and other foreign objects.

Working Principle: The grille's central mesh and intake openings channel ambient air toward the radiator and engine bay. Adequate and unobstructed airflow is essential for maintaining engine operating temperature, particularly under load and high-ambient conditions. The grille structure also provides a first barrier against stones, trash, and insects that could otherwise damage the radiator fins or fan blades.

• Dimensional Data (Supplier-Published): Length 1.05 m × Width 0.23 m × Height 0.05 m; Weight 1.1 kg. These figures can be cross-checked against the original part before installation.
• Quality Certification: Supplied under ISO/TS16949 automotive quality management system.
• Supply Capacity: 1,000 pcs/month; MOQ 10 pcs; delivery 5–10 days; neutral packaging or customer-specified.
• OEM Application Verified: OE number 8401100LD010 is independently listed across multiple parts catalogs as the correct front grille for the JAC N56 platform.
• Data Limitation: No publicly available bench-test data (impact resistance, UV aging hours, or airflow CFM) was found for this specific OE number. For stronger E-E-A-T verification, request material specification sheets or weathering test reports from the supplier.

• Visible cracks, fractures, or missing sections in the grille mesh or frame
• Mounting tabs or clips broken, causing the grille to sit loose or rattle
• Surface fading, peeling chrome, or severe UV degradation affecting appearance
• Deformation from minor impact preventing proper fitment with the bumper or hood
• Excessive debris accumulation behind the grille that cannot be cleared, indicating damaged mesh

1. Open the hood; disconnect the negative battery terminal if working near electrical components.
2. Remove the front bumper or grille retaining screws/clips as required (refer to model-specific manual).
3. Carefully release the grille from its mounting points; use a trim tool to avoid breaking tabs.
4. Transfer any reusable emblems, badges, or sensor brackets to the new grille.
5. Align the new grille with mounting holes; press clips into place until fully seated.
6. Reinstall fasteners; torque plastic screws to hand-tight only — do not over-tighten.
7. Reinstall bumper/trim; verify panel gaps are even on both sides.
8. Reconnect battery if disconnected; test hood latch and any front-facing sensors.

• Inspect grille for cracks or loose clips at every oil change or every 10,000 km.
• Clean grille mesh with low-pressure water and a soft brush; avoid high-pressure spray directly on plastic clips.
• Check for debris accumulation behind the grille (leaves, insects) and clear as needed to maintain airflow.
• Replace immediately if structural cracks or missing mesh sections are found, as debris protection is compromised.

• Packaging: Neutral package or customer request
• Suitable for: Wholesale distributors, auto body repair shops, fleet maintenance suppliers, collision repair centers
• MOQ: 10 pcs
• Supply Ability: 1,000 pcs/month
• Delivery: 5–10 days