Front Right Door Assembly 8-97581430-0 8975814300 For ISUZU NPR NQR NKR77 NKR85 — Bare Shell Without Trim, Ready To Paint, Wide-Angle Mirror Provision

The Front Right Door Assembly with OEM references 8-97581430-0 / 8975814300 is a verified replacement body panel for the ISUZU NPR and NQR light truck platform, covering a wide range of models including NPR71, NQR75, NQR70, NPR66, and NKR55. This is the complete front right-hand (RH / passenger side) door shell, supplied bare (without interior trim, glass, regulator, latch, or hardware) and ready for paint.

Euro4x4parts explicitly confirms the position as "Front — Right side" and describes the unit as "Supplied bare — Style black — ready to paint — For vehicles with mirror brackets wide angle". The wide-angle mirror provision is a defining fitment characteristic of this shell. The Turkish catalog (Guneybaglilar) further confirms the mirror hole provision, describing it as "KAPI KOMPLE AYNA DELIKLI SAG" (Door Assembly, Mirror Hole, Right), with compatible models listed as NPR66, NKR55, NQR70, NPR71, and NQR75.

The door shell is the structural and cosmetic outer skin of the door, providing side-impact protection, weather sealing, and the mounting foundation for the window regulator, latch, hinges, and mirror bracket. Because it is supplied unpainted, the body shop can apply the exact factory-matched finish for a seamless repair.

1. Confirm the required part first: Verify that the replacement is the front right (RH) bare shell and that the wide-angle mirror bracket provision matches the original door. Compare the physical dimensions and hinge mounting points.
2. Remove the original door: Support the door weight with a jack or stand. Disconnect the door check strap, wiring harness (if any), and hinge pins/bolts. Note the hinge shim configuration for alignment reference.
3. Transfer hardware: If the original hinges, latch, handle, glass, and trim are in good condition, transfer them to the new door shell. Inspect hinge pins and bushings for wear — replace if loose.
4. Pre-fit the new door: Mount the new shell on the hinges and check panel gaps and flushness before final tightening. Adjust hinge position to achieve even gaps at the front, rear, top, and bottom edges.
5. Paint preparation and finishing: The door is supplied unpainted (black, ready to paint). Clean and prep the surface according to the paint manufacturer's instructions, apply primer, base coat, and clear coat to match the vehicle's factory finish.
6. Install glass and hardware: Transfer or install the window glass, regulator, latch, handle, and trim. Check window alignment and operation.
7. Verify latch and sealing: Close the door and verify that the latch engages smoothly and the weather seal compresses evenly. Check for water intrusion points around the perimeter seal and mirror bracket area.
8. Road test: Drive the vehicle and listen for wind noise or rattles from the door area. Re-adjust hinges or latch if necessary.

• Inspect door hinges and latch at every service or every 20,000–30,000 km — lubricate hinges and latch mechanism to prevent wear and binding.
• Check weather seals for cracking or compression set — replace if water intrusion or wind noise develops.
• Inspect for rust along the lower door edge and seams, especially in coastal or salted-road environments.
• Avoid slamming the door — excessive force stresses the hinges and latch over time.

• Standard packing: Protective carton or crate with internal cushioning. Neutral / customer-branded packaging available.
• Package contents: 1 × Front Right Door Shell (bare/unpainted, without trim). Hinges, latch, handle, glass, regulator, trim, and mirror are not included unless explicitly stated — confirm exact package contents at inquiry.
• Set options: Bare shell only (standard) / shell + paint-prep service (where available) — specify at inquiry.
• Suitable for: ISUZU NPR71 / NQR75 / NQR70 / NPR66 / NKR55 body repair shops, light truck fleet maintenance departments, collision repair centers, spare parts distributors, and export wholesalers serving Southeast Asia, the Middle East, Africa, and Latin America.
• Related parts available: Front left door shell (8-97581431-0 / 8975814310), hinges, latch assemblies, window regulators, door glass, mirror brackets, and door seals for the NPR/NQR platform.