ISUZU 6WG1 OEM Cross-Reference Verified Oil Pressure Switch with 0.3 bar Switching Pressure and CE Certification
| Switching Pressure: | Approx. 0.3 Bar | Thread Size: | M10 × 1.25 |
| Material: | Metal Housing + Internal Diaphragm Contacts | Net Weight: | Approx. 0.05 KG |
| Engine Compatibility: | 6WG1 | Thread Precision: | M10*1.25 |
| High Light: | OEM Cross-Reference Verified Oil Pressure Switch,CE Certified Oil Pressure Sensor,0.3 bar Switching Pressure Engine Protection Switch |
||
Verified OEM Direct-Fit Excavator Engine Protection Switch designed for ISUZU 6WG1 diesel engines, primarily installed in Hitachi ZAXIS series excavators.
This oil pressure switch monitors engine oil pressure in real time, ensuring proper lubrication system operation and triggering alarm or protection signals when oil pressure deviates from normal range, preventing engine damage due to insufficient lubrication.
Mounted on the engine main oil gallery, the switch contains a diaphragm that displaces under oil pressure, making or breaking an electrical circuit when pressure reaches the set threshold of approximately 0.3 bar. This sends a signal to the dashboard or ECU to trigger warning lamps or engine protection programs when oil pressure drops below safe values.
- Thread Size: M10*1.25 standard thread
- Switching Pressure: Approximately 0.3 bar
- Compatible with ISUZU 6WG1 series diesel engines
- Material: High-strength aluminum alloy & precision bearings
| Part Number | 8-98249723-0 8982497230 |
| Product Name | Oil Pressure Switch |
| Condition | 100% Brand New |
| Origin | China Mainland |
| Quality Standard | OEM equivalent / ISO quality control |
- Oil pressure warning lamp stays on continuously or flashes frequently
- Warning lamp does not extinguish after engine start
- Oil pressure gauge reading abnormally high or low
- Oil seepage at switch terminal connection
- False low-pressure alarm under normal oil pressure conditions
| Brand | Model | Engine |
|---|---|---|
| Hitachi | ZX450 | 6WG1 |
| Hitachi | ZX450-3 | 6WG1T |
| Hitachi | ZX470-3 | 6WG1T |
| Hitachi | ZX470-3G | 6WG1 |
| Hitachi | ZX650 | 6WG1 |
| Hitachi | ZX650-3 | 6WG1 |
| Hitachi | ZX850 | 6WG1 |
| Hitachi | ZX870-3 | 6WG1 |
| Sumitomo | SH800 | 6WG1 |
| Case | CX800B | 6WG1 |
- Disconnect battery negative terminal for safe operation
- Place oil drain pan below switch before removing old switch to prevent oil spill
- Clean area around mounting hole; inspect threads for damage
- Apply small amount of sealant to new switch threads; hand-thread until seated
- Tighten with wrench to specified torque (consult ISUZU 6WG1 workshop manual)
- Connect harness connector; start engine and check for leaks
- Observe dashboard oil pressure warning lamp status to confirm normal operation
- Inspect switch appearance, wiring, and sealing at every engine service interval
- Check oil pressure warning function every 500 hours or 6 months
- Replace immediately upon oil seepage, abnormal alarm, or reading deviation