Front Wheel Hub Bearing 40202-ED000 40202ED000 For Nissan Tiida/Bluebird Sylphy/Latino/Cube 2004-2012 — OEM Front Axle Assembly With Integrated ABS Sensor Ring

The Front Wheel Hub Bearing Assembly with OEM number 40202-ED000 (also listed as 40202ED000) is a verified OEM-grade direct replacement for a wide range of Nissan vehicles. This critical component supports the vehicle's weight, enables smooth wheel rotation with minimal friction, and maintains proper wheel alignment for stable handling and braking performance.

If your front wheel hub bearing is failing, you may experience one or more of the following symptoms:

• Humming, Growling, or Rumbling Noises: Unusual sounds from the front wheel area that change with vehicle speed or when turning
• Steering Vibration: Steering wheel shakes or vibrates, especially at highway speeds
• Loose Wheel: Excessive play or wobbling when the wheel is jacked up and rocked
• Uneven Tire Wear: Premature or irregular tire wear patterns due to compromised wheel alignment
• ABS Warning Light: Dashboard warning light may illuminate — indicates a faulty bearing with integrated ABS ring

Compatible Brands: Nissan

Pre-Installation Checklist:

• Inspect the steering knuckle and hub mounting surface for damage or debris
• Verify the axle shaft splines are clean and undamaged
• CRITICAL: This bearing features an integrated ABS sensor ring — handle with care and keep away from strong magnetic sources

Installation Guidelines (Reference Nissan workshop manual):

1. Safely raise the front of the vehicle and support it on jack stands
2. Remove the front wheel and brake caliper (support the caliper to avoid stressing the brake line)
3. Remove the brake disc and axle hub
4. Remove the old bearing from the steering knuckle using a hydraulic press
5. Clean the bearing bore in the steering knuckle thoroughly
6. CRITICAL: Press the new bearing into the steering knuckle using the correct press tools — apply pressure only to the outer race
7. Install the hub into the bearing — apply pressure only to the inner race
8. Reinstall the hub assembly, brake disc, and caliper
9. Torque all fasteners to manufacturer's specified torque settings (refer to Nissan workshop manual)
10. Reinstall the wheel and torque lug nuts to specification
11. Test drive to verify smooth operation and check for unusual noises

Maintenance Schedule:

• Inspection: Every 50,000 km / 12 months. Listen for unusual noises, check for wheel play
• Replacement: Recommended at 100,000 km or immediately if failure symptoms appear
• Note: Always replace in pairs (both left and right sides) for even suspension and handling performance

Each wheel hub bearing is securely packed in a protective carton with anti-rust coating. Suitable for wholesale distributors, auto parts retailers, and repair shops.