Rear Brake Wheel Cylinder with Aluminum Body and 23.81mm Bore Diameter for Direct OEM Replacement in Isuzu NHR54

The Rear Brake Wheel Cylinder (OEM Number: 8-97179336-0 / 8971793360) is a premium-quality hydraulic component designed as a direct replacement for the rear drum brake system of Isuzu NHR54 light-duty trucks equipped with the 4JA1 diesel engine.

Converts hydraulic pressure from the master cylinder into mechanical force to push brake shoes against the drum, ensuring balanced and effective braking for Isuzu NHR54 4JA1 trucks.

• OE Quality: Manufactured to Isuzu dimensional and material specifications for perfect fit and reliable braking
• Precision-Machined Bore: Smooth honed cylinder bore ensures consistent piston movement and long seal life
• Corrosion-Resistant: Aluminum body with anti-corrosion treatment for durability
• High-Quality Rubber Seals: EPDM cups and seals resist DOT 3/DOT 4 brake fluid, heat, and aging
• Dust Boot Included: Protects the bore from dirt and moisture
• Leak-Tested: Each cylinder is hydraulically tested for leakage before packaging
• Restores Braking Performance: Eliminates spongy pedal, fluid leaks, and uneven braking
• Direct Replacement: Matches OE mounting bolt pattern, inlet port location, and bleeder screw position
• Cost-Effective: Affordable alternative to genuine OEM without compromising safety

This rear brake wheel cylinder is specifically designed for Isuzu NHR54 trucks with 4JA1 engine.

• ISUZU NHR54 (light-duty truck, 4JA1 engine)
• ISUZU NKR (select models with same rear brake system - verify)

• 4-Cylinder, Inline Diesel, OHV
• Displacement: 2.5L (2499cc)

Typical installation steps for rear wheel cylinder:

1. Safely lift and support the vehicle - remove the rear wheel and brake drum
2. Clean the brake assembly - use brake cleaner to remove dust and debris
3. Disconnect the brake line - from the back of the old wheel cylinder using a flare nut wrench. Cap the line
4. Remove the old wheel cylinder - unbolt the two mounting bolts from the backing plate
5. Clean the backing plate mounting surface - remove old gasket/sealant
6. Compare new cylinder with old - bore size (23.81mm), bolt spacing, and port orientation
7. Install new wheel cylinder - apply a thin film of brake grease to the mounting flange. Bolt to backing plate. Torque bolts to specification (typically 10-15 Nm)
8. Reconnect the brake line - hand-start, then tighten with flare nut wrench. Do not cross-thread
9. Reinstall brake shoes and hardware - ensure pushrods engage properly
10. Reinstall brake drum and wheel - adjust shoes if needed
11. Bleed the brake system - start from the wheel farthest from the master cylinder
12. Check for leaks - inspect the new cylinder and line fitting
13. Test drive - ensure proper braking and no pulling

• Material Verification: Body alloy and seal compound tested
• Dimensional Inspection: Bore diameter (23.81mm), bolt hole spacing, and thread pitch (M10 x 1) verified
• Leak Test (Hydraulic): Each cylinder pressurized to ensure no internal or external leakage
• Piston Movement Test: Smooth operation confirmed over full stroke
• Thread Inspection: Inlet and bleeder threads checked with GO/NO-GO gauges
• Visual Inspection: 100% checked for casting defects, scratches, or damaged ports
• Packaged Safely: Cylinder sealed in plastic bag, boxed with foam protection

• Neutral export packing or customized packaging available
• Carton or wooden case for safe transportation
• Fast delivery for stock items
• Shipping by Express Air or Sea