Gear-type or Rotor-type Oil Pump Assembly with Cast Iron / Aluminum Housing for Direct OEM Replacement in Isuzu NPR66 4HF1 Engine
Key Attributes
Product Summary
OE-quality oil pump assembly for Isuzu NPR66 with 4HF1 engine. Direct replacement with precision gears, pressure relief valve, and durable construction. Ensures reliable lubrication and engine protection.
Product Details
Gear-type oil pump assembly Isuzu NPR66
,Rotor-type oil pump OEM replacement
,Cast iron housing oil pump 4HF1 engine
| Part Number | 8-97147338-0, 8971473380, 8-98017585-0, 8980175850 |
| Product Name | Oil Pump Assembly / Engine Oil Pump |
| Car Model | ISUZU NPR66 |
| Engine Model | ISUZU 4HF1 (3.9L Diesel) |
| Condition | 100% Brand New |
| Origin | China Mainland |
| Warranty | 6 Months |
| Material | High-strength aluminum alloy & precision bearings |
- OE Quality: Manufactured to Isuzu dimensional and material specifiions for perfect fit and reliable oil pressure
- Precision Gears/Rotors: Hardened and ground to tight tolerances for consistent flow and minimal noise
- Integrated Pressure Relief Valve: Prevents over-pressurization at high RPM, protecting oil filter and seals
- Durable Housing: Corrosion-resistant cast iron or aluminum construction withstands engine heat and vibration
- High Flow Capacity: Delivers adequate oil volume for turbocharger cooling and piston jets under high load
- Restores Engine Protection: Eliminates low oil pressure, knocking, and bearing wear
- Direct Replacement: Matches OE mounting holes, drive gear interface, and oil passages
- Cost-Effective: Affordable alternative to genuine OEM without compromising reliability
- 4-Cylinder, Inline Diesel, Direct Injection
- Displacement: 3.9L (3856cc)
- Appliion: NPR66, NKR, and industrial equipment
- Drain engine oil - remove oil pan and clean sealing surfaces
- Remove old oil pump - unbolt from engine block. Note gasket or seal orientation
- Clean mounting surface - remove old gasket material. Ensure no debris falls into the engine
- Prime the new oil pump - fill with clean engine oil or pack with assembly lube to ensure immediate suction on startup
- Install new pump - use new gasket or O-ring. Torque mounting bolts to specifiion (typically 20-30 Nm)
- Reinstall oil pan - with new gasket or sealant. Torque pan bolts
- Install new oil filter - pre-fill if possible
- Refill with new engine oil - correct grade and quantity
- Prime the lubriion system - disable fuel system and crank engine for 10-15 seconds until oil pressure light goes out
- Start engine - check oil pressure light goes off immediately. Inspect for leaks
- Test drive - verify normal oil pressure and no unusual noise
- Material Verifiion: Housing and gear alloy composition tested
- Dimensional Inspection: Gear clearances, housing bore diameters, and mounting flange verified
- Flow/Pressure Test: Pump tested on a test bench for flow rate and pressure at specified RPM
- Relief Valve Test: Valve opening pressure verified
- Wear Test: Sample pumps run for durability cycles
- Visual Inspection: 100% checked for casting defects, burrs, or contamination
- Packaged Safely: Pump sealed in plastic bag, boxed with foam to protect ports and drive gear